Blog

Watch the video here! VRS 4150 dyno and drag strip testingIn this video, we take a deep dive into Edelbrock's new race carburetor—the VRS-4150. Instead of just doing a typical box-opening, I put this 850 CFM carb through its paces with actual applied testing across three different engines (a 5.3L LC9, a 427 LS Stroker, and a stock bottom end LS3). I compare its features, installation quirks, dyno performance, and drag strip results directly against my tried-and-true Quick Fuel Q850 ra …

Mastering the MSD 6014: How to Wire and Install Your Carbureted LS Engine Control At Scram Speed, we build and tune a wide variety of LS combinations, from extreme twin-turbo Holley Dominator setups to simple, reliable street cars. But when it comes to raw bang-for-the-buck performance and clean engine bay execution, a carbureted LS engine with an MSD 6014 LS Ignition Control is tough to beat. Installing the MSD 6014 is vastly simpler and more affordable than wiring a full EFI swap, especially i …

The Ultimate Holley Terminator X Installation Guide for Fox Chassis & 5.0 Ford Mustangs If you are upgrading your 5.0L Fox Chassis vehicle to modern Electronic Fuel Injection (EFI), you’ve likely encountered conflicting advice, incomplete wiring guides, and off-the-shelf kit limitations online. In this complete step-by-step walkthrough, Kyle installs a Holley Terminator X system on a classic 1980 Ford Futura—a platform built on the exact same Fox chassis as the 1987–1995 Fo …